Installation of inspection hatches

Modern housing is replete with a large number of different communications.. electrical wiring, water distribution, ventilation ducts, chimneys. All of this is working properly., while new. But for all these systems to work just as successfully and further, it is necessary to carry out routine repairs in a timely manner. In order not to be late, do regular checkups more often, preventing possible damage. What is the risk of failure of ventilation and chimney systems, everyone knows. They can easily become clogged with street debris., carcasses of birds and other living creatures. Therefore, it is important to ensure free access to all communications, installing inspection hatches.

If they are present, do not try to remove these hatches. Even if they greatly spoil the aesthetic appearance of the room. It is best to try to combine hatches with the interior. Otherwise, you may run into penalties when inspecting the premises by the gas service.

When you choose inspection hatches be careful. It is not enough to consider only their appearance and the necessary dimensions.. It is recommended to study them in more detail during the selection process.. It consists of a metal box and a door.. Structurally, many hatches have tight-closing doors, which are hard to open. Therefore, when opened, they can be pulled out completely., with all content, since they can only be inserted into the opening, or, best case scenario, glued. In such cases, it is necessary to open hatches, holding the body with one hand. This will be problematic, since it does not have special handles, make it become everything.

If you have to mount such hatches yourself. Remember, that it is necessary to drill holes in the hatch box. Hole diameter must be at least eight millimeters, but not very big. It is recommended to clean the surface of the opening from dust and debris., then primed. After the primer is completely dry, you can start installing the hatch.

To do this, apply glue or liquid nails to the outer part of the box.. And install it in the prepared opening. Desirable, so that there is a gap around the perimeter. After, how liquid nails will glue the hatch, you can begin to finalize it. Mounting foam is perfect for this..

First, holes and concrete are wetted with water using a spray gun.. After that, these holes are filled with mounting foam.. After the foam has hardened, cut off excess foam. And that's it, the inspection hatch is securely installed and fixed.