Automation for deep well pump GRUNDFOS: principle of operation and application

Published by Nikoloz on 14.04.202114.04.2021

There are many fields of application of deep-well pumps, but the main one is the supply of drinking water from the well to the consumer's house. Automation can be as simple (relays and various sensors), so difficult enough (pump control cabinets) with the ability to dispatch and control a bundle of several pumps in different operating modes. so, Automation for the deep pump can be represented by several control mechanisms and fuses. The most demanded pressure sensors in the hydraulic tank and relay, capable of increasing pressure, When necessary. Automation for deep well pump GRUNDFOS

You can very carefully operate the well, but unable to protect the technique from spontaneous voltage drops, Therefore, buying automation for the deep pump will not be superfluous. Even its minimum set will simplify its use and extend the service life of the water supply system of your home.

Automation for a submersible pump Groundfos

Submissive pumps of the Groundfos are used to pump water from drainage, Polodsev and reservoirs. This type of pump is usually trouble -free in operation. However, its cornerstone is the inability to work without water: In this case, the pump is subjected to increased loads and quickly fails. Good protection against these and other troubles can be automation for the submersible pump Groundfos.

During operation in conditions, far from optimal, it may be necessary to replace some Grundfos spare parts: Pressure or power control relay. The instability of the aquifer or error when selecting the pump power (More laid) can cause the periodic replacement of the dry relay. It would seem, Automation - additional consumables, But its absence or malfunction can lead to more serious breakdowns and finally disable the pump. As you can see, Buying automation for a submersible pump Groundfos - much cheaper to replace the mechanism itself.

Why buy a water pressure relay for the pump and how to make a choice?

Typically, the system of autonomous aquifer consists of a pumping pump, hydro -accumulating system and pressure relay. In addition to the hydraulic tank relay, there are a relay for a heating pump. Their main task is to make water supply to the system automatic and facilitate control over its level, in order to prevent premature wear. A competent choice of relay will turn your hydraulic pump into a fully automatic station.

What should determine the criteria for choice? Not a price - that's for sure. But the reliability and level of isolation, The simplicity of installation and adjustment is exactly what, What should you pay attention to. To “bonus”, on which the price depends, include the settings range and additional functions.

The parameters of most units are similar, So most likely you will have to focus on the price-quality ratio. You can bring another criterion: The nodes of one manufacturer usually work more well, So it is better to buy a water pressure relay for a pump of the same brand, that the installation itself.

Purchase automation and other quality Grundfos spare parts You can at the Baymart store. Always in stock: